Share your interactive ePaper on all platforms and on your website with our embed function. Two versions of the probe burn off are available: batch furnace and continuous furnace. You can set burn off time and purge time, each for one to 15 minutes. If power to the controller is disrupted, timers will reset to zero when power is restored.
It will display the last result, and store it for later recall. Output status is changeable through RS command writes. Upper Display: 4 digits, 7 segment green LEDs with decimal point, 0. Middle Display: 4 digits, 7 segment orange or amber LEDs with decimal point, 0. Lower Display: 4 digits, 7 segment orange or amber LEDs with decimal point, 0.
Bargraph: Column of 33 green LEDs indicate process variable value, or deviation error. Column of 33 orange or amber LEDS indicate operating setpoint, or process out value. OUT10 indicate optional digital output. Type of input is keyboard and jumper selectable. Burn Off Two versions of the probe burn off are available: batch furnace and continuous furnace.
In both versions, burn off interval, burn off duration, and recovery duration are keyboard selectable, or downloadable through RS serial link. The burn off interval for a batch furnace can be initiated from an external event, or from the controller keyboard. You can set burn off duration and recovery duration, each for one to 15 minutes. When burn off and recovery are complete, normal control is resumed.
In a continuous furnace, burn off interval can be initiated by an internal timer, or from the controller keyboard. You can set the burn off internal timer to start at any interval of one to 24 hours. When burn off and purge is complete, normal control is resumed by returning to automatic control Super Systems, Inc. Extended embed settings. You have already flagged this document.
